LIFTING MACHINE
4108AN
Page 1-11
FORKLIFTING MACHINE
Forklifting Procedure
WHEN USING A FORKLIFT TO
MOVE THE MACHINE ONLY THE
FORKLIFT POCKETS LOCATED AT
THE REAR OF THE MACHINE
SHOULD BE USED.
Prior to using a forklift to lift the
machine, ensure that the mast is
lowered to the stowed position, the
lights are stowed and the engine
generator is shut down.
The machine can weigh up to 1700kg
depending on options. Ensure that only
a suitable forklift with adequate
capacity is used to lift the machine.
When positioning the forklift tines into
the forklift pockets, ensure the tines go
through far enough to pick up the tine
support bar located across the main
frame of the unit. Tine penetration
should be at least 800mm from the
rear wall of the light tower.
CRANING MACHINE
Craning Procedure
USE ONLY THE 4 LIFTING POINTS
PROVIDED TO LIFT THE LIGHTING
TOWER WITH A CRANE. DO NOT
LIFT THE ASSEMBLY BY THE
MAST. DOING SO WILL RESULT IN
SEVERE DAMAGE TO THE UNIT
AND POSSIBLE INJURY TO THE
PERSONNEL UNDERTAKING THIS
TASK.
The mast and lights should be in the
stowed position and the engine
generator shut down prior to lifting the
machine off the ground. Ensure all
outrigger legs and the draw bar are in
the retracted and locked position.
Using suitable lifting equipment
attached to the lifting lug at each
corner of the machine, proceed to lift
the machine as per the instructions
provided for the lifting crane.
!
!
