MACHINE SET UP AND PACK UP
4108AN
THE NEXT STEPS REFER TO
RAISING THE MAST. CHECK
AND
ENSURE
THAT
NO
OBSTRUCTIONS ARE LOCATED
ABOVE THE UNIT TO A HEIGHT
OF 10 METERS. REFER ALSO
TO SAFE DISTANCES FROM
POWER LINES AS DESCRIBED
IN
SECTION
1
(SAFETY
PRECAUTIONS).
9. Slowly operate the light bar tilt
hydraulic lever and hydraulic
controls enable switch to move the
light bar forward, up and away from
the front of the tow hitch.
10. Operate the lift control lever and
hydraulic controls enable switch to
continue to raise the mast to full
elevation.
11. Operate the telescope lever and
hydraulic controls enable switch to
extend the mast to desired height.
12. Finally, adjust the light bar tilt to the
desired angle by operating the tilt
control lever and hydraulic controls
enable switch.
TO AVOID CRUSHING INJURY KEEP
HANDS AND ARMS AWAY FROM
MOVING PARTS OF THE MAST.
Turning Lights On
13. Start the engine by switching on the
ignition switch, turning the key anti
clockwise to the Glow Preheat
position for 10 seconds and then
turn to the right to start the Engine.
Once started, allow the engine to
warm for a minute prior to using.
!
14. Switch on main circuit breaker to
switch on the lights.
15. Allow lights to warm up and reach
full brightness (about 3 minutes).
NOTE:
The lamps used are a Metal
Halide Gas Discharge type. If they
are switched off and back on again
after they have been running they
may take up to 15 minutes to re-
ignite. This is normal for this type of
lamp.
!
Page 1-9
