SECTION 5 - JLG CONTROL SYSTEM
5-2
– JLG Lift–
3121273
Using the Analyzer:
With the machine power on and the analyzer connected
properly, the analyzer will display the following:
HELP:
PRESS ENTER
At this point, using the
RIGHT
and
LEFT
arrow keys, you
can move between the top level menu items. To select a
displayed menu item, press
ENTER.
To cancel a selected
menu item, press
ESC
; then you will be able to scroll
using the right and left arrow keys to select a different
menu item.
The top level menus are as follows:
HELP
DIAGNOSTICS
SYSTEM TEST
ACCESS LEVEL
PERSONALITIES
MACHINE SETUP
CALIBRATION
EMULATION MODE
If you press
ENTER
, at the HELP:PRESS ENTER display,
and a fault is present, the analyzer display will scroll the
fault across the screen. If more than one fault is present
only the highest priority fault will show. The other active
faults are viewable in Logged Help. If there was no fault
detected, the display will read:
In platform mode
,
HELP: (001)
EVERYTHING OK,
In ground mode
,
HELP: (002)
GROUND MODE OK
If
ENTER
is pressed again, the display moves to the fol-
lowing display:
LOG: (211)
1: Power Cycle
(Or last recorded fault)
At this point, the analyzer will display the highest priority
active fault, if any are present. You may scroll through the
fault logs to view what the last fifteen faults were. Use the
right and left arrow keys to scroll through the fault logs.
The active faults, are listed before the first POWER
CYCLE. To return to the top menu, press
ESC
two times.
When a top level menu is selected, a new set of menu
items may be offered; If for example you choose Personal-
ities:
DRIVE
LIFT
STEER
GROUND
Pressing
ENTER
with any of the above displayed menus,
will display additional sub-menus within the selected
menu. In some cases the next level is the parameter or
information to be changed. Refer to the flow chart for what
menus are available within the top level menus. You may
only view the personality settings for selected menus
while in access level 2. Remember, you may always can-
cel a selected menu item by pressing the
ESC
key.
MENU:
HELP:PRESS ENTER
l og: ( 211)
