SECTION 3 - CHASSIS & SCISSOR ARMS
3121273
– JLG Lift –
3-33
Hub Assembly
1. Put hub on a table with the tapped holes facing
down.
2. Using a flat plate in conjunction with a pressing tool,
press in the seal so it is flush with the edge of the
hub.
NOTE:
The seal has a thin outer shell that can be easily
damaged if not installed with care. It is a good idea
to start the seal into the bore with a rubber mallet
before pressing.
3. Flip the hub over.
4. Using an appropriate pressing tool, press the main
bearing into the bore until it bottoms out.
Figure 3-36. Hub Assembly
1.
Seal
2.
Hub
3.
Main Bearing
