SECTION 3 - CHASSIS & SCISSOR ARMS
3-20
– JLG Lift –
3121273
Brake - Manual Disengage Procedure
NOTE:
The brakes may also be disengaged electrically
using the brake release switch, see procedure in
Operation Manual.
CAUTION
CHOCK WHEELS OR SECURE MACHINE WITH TOW VEHICLE.
1. Ensure battery disconnect switch is in to the "OFF"
position.
2. Start with either of the drive motors and remove the
two cover bolts
and
brake cover.
3. Thread the cover bolts into the two disengage holes
in the brake housing.
4. Tighten down the cover bolts so the brake on that
drive motor will disengage.
5. Repeat this procedure on opposite wheel drive. With
both drive motor brakes now disengaged, the
machine can be moved manually.
6. After towing is complete, chock wheels and remove
cover bolts from disengage holes.
7. Reinstall brake cover, replace cover gasket if dam-
aged.
CAUTION
AFTER THE MACHINE IS TOWED, THE COVER BOLTS MUST BE
REMOVED FROM THE BRAKE DISENGAGE HOLES. THE BRAKES
CANNOT BE ENGAGED WITH THE DISENGAGE BOLTS IN THE
BRAKE DISENGAGE HOLES. THIS WILL CAUSE THE MACHINE
TO ROLL WHEN PARKED ON AN INCLINE.
Figure 3-22. Brakes - Manual Disengage Procedure
1.
Cover Bolts
2.
Brake Cover
3.
Cover Gasket
4.
Disengage Holes
1
2
4
3
