JLG 1532R, Operation And Safety Manual

Page: 72 / 98

SECTION 5 - GENERAL SPECIFICATIONS AND MAINTENANCE
5-10 – JLG Lift – 3121744
Hydraulic Oil Check Procedure
(See Figure 5-2. and Figure 5-
3.)
Lube Point(s) - Hydraulic Reservoir
Reservoir Capacity - See Table 5-8 on page 5-7.
Lube - Hydraulic Oil
Interval - Check Daily
NOTE: Check the hydraulic oil level with the platform in the
stowed position ONLY. Be certain the hydraulic oil has
warmed to operating temperature before checking the oil
level in the reservoir.
1. On the right side of the machine on the hydraulic
compartment door there is a
cutout (1) which allows
viewing of the hydraulic oil tank marking (2) . The res-
ervoir is marked with a MAX (maximum) marking (2) .
The MIN marking (3) is the bottom edge of the cutout
on the door. The oil level must be kept within these
markings for the hydraulic system to operate properly.
2. If additional oil is required, swing compartment door
open and wipe all dirt and debris from the
filler/filter
cap (4) area. Remove filler cap and add proper grade
of oil. Fill until oil level is close to the MAX marking
(3), but not over the MAX marking .
NOTE: Care should be taken not to introduce any impurities (dirt,
water, etc.) while cap is removed.
Prop Engaged
Prop Disengaged
Figure 5-1. Scissor Arm - Safety Prop