10
JL AUDIO
CleanSweep
®
CL-SES
“My CL-SES doesn’t turn on.”
Check
to make sure there is +12V at the
“+12V”
to make sure there is +12V at the
to make sure there is +12V at the
and “
IGN
” power
connections of the CL-SES. Also check the ground connection.
Check
the fuse, not just visually, but with a continuity meter. It is
possible for a fuse to have poor internal connections that
cannot be found by visual inspection. It is best to take the
fuse out of the holder for testing. If no problem is found with
the fuse, inspect the fuse-holder.
“My system has alternator whine when using the CL-SES.”
Check
that the CL-SES is grounded to the same point as the
amplifier(s) in the system and that all its connected sources
deriving power from the vehicle are also grounded with
the amplifier(s).
Check
the input connectors and cables to ensure that they all are
making good contact with the input jacks on the CL-SES.
“On some songs, my CL-SES switches when it is not supposed to.”
Please
review the functional description of the automatic mode
on page 6 of this manual. This may occur with songs that
contain very quiet passages or that fade in or out very
gradually. If this behavior is not acceptable, consider using
the unit in “manual mode” with the included switch.
“One source unit is much louder than the others.”
Please
use the level trim controls on that input to attenuate the level
of the source that is too loud to match the other source units.
TROUBLE SHOOTING
Summary of Contents for CleanSweep CL_SES
Page 11: ...JL AUDIO CleanSweep CL SES 11 ...
