JL Audio CleanSweep CL_SES, Owner'S Manual

Page: 3 / 12

JL AUDIO CleanSweep
®
CL-SES 3
INSTALLATION APPLICATIONS
This product is designed for operation in
vehicles with 12V, negative-ground electrical
systems. Use of this product in vehicles with
positive ground and/or voltages other than 12V
may result in damage to the product and will void
the warranty.
This product is not certified or approved
for use in aircraft.
PLANNING YOUR INSTALLATION
It is important that you take the time to
read this manual and that you plan out your
installation carefully.
Safety Considerations:
Your CleanSweep® CL-SES needs to be installed
in a dry environment and in a manner which does
not interfere with your vehicle’s safety equipment
(air bags, seat belt systems, ABS brake systems,
etc.). You should also take the time to securely
mount the CleanSweep® CL-SES so that it does not
come loose in the event of a collision or sudden
acceleration / deceleration.
Stupid Mistakes to Avoid:
• Check before drilling any holes in your vehicle to
make sure that you will not be drilling through a
gas tank, brake line, wiring harness or other vital
vehicle system.
• Do not run system wiring outside or underneath
the vehicle. This is an extremely dangerous
practice that can result in severe damage to your
vehicle and person.
• Protect all system wires from sharp metal
edges and wear by carefully routing them,
tying them down and using grommets and
loom where appropriate.
• Do not mount this product in the engine
compartment, under the vehicle, on the
roof or in any other area that will expose it
to the elements.
PRODUCT OVERVIEW
The CL-SES is a high-quality audio source
switch which allows you to expand any single
stereo auxiliary input to accept up to three stereo
source units. The CL-SES can be used to expand
the auxiliary input capabilities of an OEM
interface processor or any head unit that provides
an auxiliary line-level input, including many
OEM head units.
The CL-SES utilizes differential-balanced
inputs to provide superior noise immunity and
ensure compatibility with a wide range of source
units. Advanced, solid-state CMOS switching
ensures clean, distortion-free audio with no
mechanical contacts to wear or corrode.
Switching between source units can be
accomplished via automatic signal sensing OR
manually operated switch (included):
Automatic Mode uses signal-sensing to switch
between source units. You determine which
source units have priority over others and select
between them simply by turning them on or off.
Manual Mode uses the included remote push-
button to switch between source units. When
you are finished with a particular source, press
the switch to go to the next source. Active inputs
switch in sequence from “A” to “B” to “C” and
then back to “A”, etc.
Level-trim controls are provided for each
input to aid in achieving equal sound levels
between sources.
Each input has a corresponding LED indicator
(located on the top panel of the CL-SES) to
indicate when it is the active input.