Continued on Next Page
SMS-F150-SPRCRW INSTR_SKU# 011341
Page 6 • JL Audio, Inc., 2013
S T E P 2 0
Mount the Crossover to the Crossover Bracket with a pair
of #8 x 3/4” Screws. Connect 16 AWG Speaker Cable to the
Crossover. Connect the wires from the woofer and tweeter
outputs of the Crossover to the woofer and tweeter inputs
of the speaker. Connect the wire from the Crossover input to
the factory wire using the following guide:
Basic Premium
Left Front (+) = white white/brown
Left Front (-) = white/brown white
Right Front (+) = white/violet white/orange
Left Front (-) = white/orange white/violet
S T E P 2 4
Remove the two torx bolts under the seat.
S T E P 2 3
Remove the four seat bolts on the floor.
S T E P 1 8
Route three runs of 16 AWG Speaker Cable from the
Crossover location to the speaker hole. Be sure to keep
the cables away from any moving parts such as the power
window motor.
S T E P 2 2
Repeat
Steps 5-21
for the driver’s side.
S T E P 1 7
Slide a pair of Speed Clips over the holes in the Crossover
Bracket, and mount the bracket to the two factory holes
using a pair of 10 - 24 x 3/8 Machine Screws and 10 - 24 Keps
Nuts as shown.
S T E P 2 1
Pictured is the Crossover.
Premium System
:
Set the MIDRANGE PRESENCE jumper in the LOW position
and the TWT LEVEL jumper in the -2dB position.
Basic System
:
Set the MIDRANGE PRESENCE jumper in the LOW position
and the TWT LEVEL jumper in the REF position.
Verify operation of the speaker, and reinstall the door panel.
S T E P 1 9
Reinstall the barrier, then locate the two Speed Clips in the
Crossover Bracket as shown.
