Continued on Next Page
SMS-F150-SPRCRW INSTR_SKU# 011341
Page 12 • JL Audio, Inc., 2013
S T E P 6 8
Install the Fuse Holder within a few inches of the battery, and
secure the ring terminal to the positive battery post.
Do not install the fuse at this time.
S T E P 7 2
Premium System:
Using the color code in
Step 48
as a guide, connect the
front Audio Interconnects to Inputs 1-2 and the rear Audio
Interconnects to Inputs 3-4.
Basic System:
Using the color code in
Step 63
as a guide, split the front
Audio Interconnects with the pair of Y-adaptors and connect
them into Inputs 1-2 and 5-6. Connect the rear Audio
Interconnects to Inputs 3-4.
Connect the 16 Gauge Speaker Cables for the front speakers
to the amplifier Outputs 1-2, and the rear to Outputs 3-4.
S T E P 7 1
Route the 4 Gauge Power Wire, 4 Gauge Ground Wire,
Remote Turn-on Wire, and the HD-RLC cable to the amplifier,
and connect the cables to the amp as indicated. Connect
the 12 AWG Speaker Cable to the Subwoofer Output of the
amplifier and route to the Stealthbox® location.
S T E P 6 6
Locate the grommet on the passenger’s side firewall.
S T E P 7 0
Carefully unclip and remove the passenger’s side rear door
sill panel. Drill a 1/2” hole under the panel, scrape away the
paint, and secure the 4 Gauge Ground Wire using the Master
Ground Lug as shown.
Before drilling, always make sure that you are not
going to be drilling into any gas lines, brake lines,
tires, transmission lines, electrical wiring, exhaust
systems or anything else that might cause a reduction
in your weekly pay.
S T E P 6 5
Route the cable for the HD-RLC to the desired remote
location, and mount the control knob as described on the
package for the HD-RLC. Route the 16 AWG Speaker Cable,
Audio Interconnects, and HD-RLC cable under the carpet to
the new amplifier location.
Reinstall the head unit, dash bezel, driver’s and passenger
side trim bezels on vehicles without the premium system.
Reinstall the center console.
S T E P 6 9
Carefully unclip and remove the passenger’s side front door
sill panel and kick panel. Unplug Fuse 38, and install the Fuse
Adaptor in its place. Connect the Remote Turn-on Wire to
the Mini Fuse Add-A-Circuit.
Do not install the fuses at this time.
S T E P 6 7
Cut a hole in the upper portion of the grommet and pass the
4 Gauge Power Wire through the hole as shown.
