Continued on Next Page
SMS-F150-SPRCRW INSTR_SKU# 011341
Page 14 • JL Audio, Inc., 2013
S T E P 8 4
Slide a 3/8” Flat Washer over a 3/8 - 16 x 1-3/4” Hex Bolt, and
drop the assembly through each bracket and hole in the
floor.
S T E P 8 8
Align the Trim Panel with the Stealthbox®. Lift the carpet
flap to access the hole in the panel. Using a 1/8” drill bit, drill
through the hole in the Trim Panel and into the Stealthbox®
as shown.
S T E P 8 7
Repeat for the opposite side. Connect the 12 Gauge Speaker
Cable to the Stealthbox®.
S T E P 8 2
Align an Enclosure Bracket with each of the impressions in
the Wax Squares, and mark the hole location as shown.
S T E P 8 6
Put the Stealthbox® back into the vehicle and secure the
Enclosure Brackets to the enclosure with a pair of 1/4 - 20 x
1-1/2” Hex Drive Bolts as shown.
S T E P 8 1
Press down firmly on the Stealthbox® to leave impressions
of the Enclosure Brackets on the Wax Squares. Remove
the enclosure, leaving the Wax Squares stuck to the floor.
Remove the Enclosure Brackets from the Stealthbox®.
S T E P 8 5
From under the vehicle, place a 3/8” Fender Washer, a 3/8”
Split Lock Washer, and a 3/8” Hex Nut on each of the 3/8 - 16
x 1-3/4” Hex Bolts, and firmly tighten.
S T E P 8 3
Using a 3/8” drill bit, drill through the hole locations marked
in the previous step.
Before drilling, always make sure that you are not
going to be drilling into any gas lines, brake lines,
tires, transmission lines, electrical wiring, exhaust
systems or anything else that might cause a reduction
in your weekly pay.
Always wear eye protection when drilling!
