How to use this device
04/2019
1013658-03B
Operating instructions – 55/110
12.6.1
Navigation
Via the Control Center the most important settings can be made before start-
ing the device. During the tanning session, functions may be activated or
deactivated via the control panel inside the device.
Navigation unit - Control Center
The Control Center enables comfortable access to special functions.
Acknowledge selection.
This button's availability is displayed on the Control Center,
depending on the function that has been selected.
Select device function.
Functions or settings can be activated, deactivated or
changed.
NFC
1
-Point
Data exchange via contactless near field communication –
individual settings can be stored on a chip card and called up
again during the next session.
Information about the setting options can be found in the separate document
'Control Center' #1014640-.. which is provided in the Technical Documenta-
tion folder.
NOTE:
Only for the studio operator:
To open the Professional Setup Manager, press button
for approximately 3 seconds in standby mode.
All of the pictograms displayed on the screen are illuminated in default mode
after the device starts up.
The relevant pictogram will start to flash after a device function has been
selected. The settings or selection options available for the selected function
will be displayed on the screen.
NOTE:
Pressing and holding
button for 3 seconds activates the
demo mode. This allows you to demonstrate the following
functions without tanning.
NOTE:
If no button is pressed within 8 seconds, the settings return to
default mode.
1
Communication system: NFC (Near Field Communication);
ISO/IEC 14443A/MIFARE max. operating range: approx. 50 mm, frequency range: 13.56 MHz