
PAGE 60 of 140
6.
Mount the yoke to the opposite side of the base using the supplied 3 mm
hex driver
(Fig. 134)
.
TIP
: Keep the yoke level with the base as to ensure no conflicts with the
plunger/set screw attached to the yoke.
7.
Locate the recessed M3 screw on the bottom of the probe holder.
Unscrew the stop post using a 1.5 mm hex wrench
(Fig. 40)
until it has
cleared all obstructions. Do not remove stop post
(Fig. 135)
.
8.
Raise the stop post on the opposite side until the side of the post clearly
contacts the 90° stop point on the probe holder’s base
(Fig. 136)
.
Fig. 134 - Screw yoke to opposite side
Fig. 135 - Lower 90° stop post
Fig. 136 - Raise opposite 90° stop post
Fig. 137 - Reversed probe holder