PAGE 23 of 53
CE0120 Rev 05
4.15. Vertical Probe Holder
A
Latch
B
Probe Holder Adjustment Knob
C
Vertical Adjustment Knob
D
Pivot Buttons
E
Probe Holder Arms
F
Yoke
G
Probe Holder Arm Adjustment Knob
H
Transverse Adjustment Screw
I
Frame Bar
4.15.1. Probe Holder Setup
To mount a UT wedge in the probe holder, follow these steps:
1.
The probe holder adjustment knob allows the probe holder to be attached
to a frame bar, as well as horizontal positioning on a frame bar
(Fig. 89)
.
2.
Vertical adjustment knob allows the vertical probe holder height adjustment
(Fig. 90)
.
3.
Position the pivot buttons where necessary, When narrow scanning footprint
is required, use the pivot button holes closets to the yoke
(Fig. 91)
.
TIP:
Probe pivoting may be impeded when closer to the yoke.
D
E
H
F
G
B
C
I
A
Fig. 88
- Vertical probe holder
Fig. 89
- Adjust on frame bar
Fig. 90
- Vertical adjustment
Fig. 91
- Place buttons
