Jidé s.a. – Rue des Meuneries 11 – B-4650 HERVE (Belgique) – Tél. +32 87 31.75.12 – Fax +32 87 31.75.11 –
CARINO (EN) February 2020
26
Installation and connection of the insert
Before placing the device in its housing, ensure that points in previous chapter (site preparation)
are respected.
For an easier handling of the device, remove the door of the insert.
To take the door off, remove the six screws by means of a key or a Phillips socket PH2.
Note: the door is self-supporting on the top of the heating chamber. Nevertheless, remove the
screws carefully because the airtight seal can have a spring effect.
Once the screws are removed, raise the door by placing one hand under the glass and the other on
the side. Place the door carefully and stably in a safe place. Do not place the door on its face without
covering (blanket, foam …).
Place the device on a table or another holder, ideally of the same high than the fireplace base, close
to its fitting zone.
Connect electricity for ventilation and fit the gas flexible by the chosen hole of convection chamber.
For an easier access, it is possible to take off the whole gas drawer by sliding.
Summary of Contents for CARINO 67
Page 48: ......
