JF 1600-AT S3, Instruction Manual

Page: 181 / 240

Instructions Manual
61
4. Preparation
ENGLISH
How to change the chopped size:
4.10- Theoretical Length of Cut
Different cutting sizes can be obtained,
changed according to the gears used and
the number of chopper rotor knives. Possible
sizes range from 3 to a maximum of 55 mm.
The table below shows the possible cuts, their
gear pairs and the number of knives required
to obtain each size.
ATTENTION!
Turn off the tractor and remove
the ignition key before starting
the following procedure.
C
B
A
Cutting
gears
1.
Remove the two nuts and washers (A);
2.
Remove the cover (B) from the cutter set
box;
3.
Note in the table above which pair of gears
should be mounted to obtain the desired
chop size;
4.
Change the gears (C);
5.
Replace the gearbox cover, the nuts and
the washers (C);
THEORETICAL LENGTH OF CUT