JEWELL TuffTilt Digital, Manual, Page: 16 / 43

B-06-1006, Rev. E Tuff Tilt Digital 15
Firmware Commands
Valid commands are listed below. Some commands have more than one string to trigger the
command. “tt” stands for the target ID (99) and “ss” stands for the source ID (00). Settings stored in
nonvolatile memory remain in effect until disabled, even after a power cycle.
---------------------------------------
XY Outputs a single tilt measurement. The format of the output
depends on the setting of the SO command.
Syntax: *ttssXY<CR><LF>
Error Strings: None.
Default: N/A
Persistence: N/A
Example:
command: *9900XY<CR><LF>
response: $YXXDR,A,-00.920,D,N,A,-00.210,D,E,C,030.045,C,T-N1212*57
---------------------------------------
SO Selects the output format for the XY command. The possible formats
are:
-SIM
$x.x,y.y,t.t,sn<CR><LF>
| | | |
| | | Serial number
| | Temperature of tiltmeter
| Y-tilt value in degrees
X-tilt value in degrees
Example:
$-00.920,-00.210,030.045,N1212
-XDR
$YXXDR,A,x.x,D,N,A,x.x,D,E,C,x.x,C,T-sn*hh<CR><LF>
| | | | | | | | | | | | | |
| | | | | | | | | | | | | Checksum
| | | | | | | | | | | | Serial number
| | | | | | | | | | | Comment, T for temperature
| | | | | | | | | | Units, C=degrees C
| | | | | | | | | Temperature of tiltmeter
| | | | | | | | Data Type, C=Temperature
| | | | | | | Comment, E for East/West (X) direction
| | | | | | Units, M=microradians, D=degrees
| | | | | X (E)-tilt value
| | | | Data Type, A=Angular
| | | Comment, N for North/South (Y) direction
| | Units, M=microradians, D=degrees,
| Y (N)-tilt value
Data Type, A=Angular
Example:
$YXXDR,A,-00.920,D,N,A,-00.210,D,E,C,030.045,C,T-N1212*57