27
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], user can make further settings in the following items:
Device Settings
Change Settings
Use this item to select an optimal setting for Super IO Device.
The optional settings: [IO=2E0h; IRQ=11;]; [IO=3F8h; IRQ=3,4,5,7,10,11;];
[IO=2F8h; IRQ=3,4,5,7,10,11;]; [IO=3E8h; IRQ=3,4,5,7,10,11;]; [IO=2E8h;
IRQ=3,4,5,7,10,11;]; [IO=3E0h; IRQ=3,4,5,7,10,11;]; [IO=2E0h;
IRQ=3,4,5,7,10,11;].
*
Note:
‘Serial Port 6’
item may or may not show up, depending on different
chipset.
Q470E chipset supports this item.
WatchDog Reset Timer
Use this item to enable or disable WDT reset function. When set as [Enabled], the
following sub-items shall appear:
WatchDog Reset Timer Value
User can select a value in the range of [4] to [255] seconds when ‘WatchDog
Reset Timer Unit’ set as [Sec]; or in the range of [4] to [255] minutes when
‘WatchDog Reset Timer Unit’ set as [Min].
WatchDog Reset Timer Unit
The optional settings: [Sec.]; [Min.].
ATX Power Emulate AT Power
This item support Emulate AT power function, MB power On/Off control by power
supply. Use needs to select ‘AT or ATX Mode’ on MB jumper at first
(refer to
JAT_ATX
jumper setting for ATX Mode & AT Mode Select).
Case Open Detect
Use this item to detect case has already open or not, show message in POST.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], system will detect if COPEN has been short or not (
refer to
COPEN
jumper setting for Case Open Detection
); if Pin 1&2 of
COPEN
are short,
system will show Case Open Message during POST.
PC Health Status
Press [Enter] to view current hardware health status, make further settings in
‘
SmartFAN Configuration
’ and set value in ‘
Shutdown Temperature
’.
►
SmartFAN Configuration
Press [Enter] to make settings for ‘
SmartFan Configuration
’:
SmartFAN Configuration
CPUFAN1 / SYSFAN1 / SYSFAN2 Smart Mode
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
CPUFAN1 / SYSFAN1 / SYSFAN2 Full-Speed Temperature
Use this item to set CPUFAN/SYSFAN full speed temperature. Fan will run at full
speed when above this pre-set temperature.
CPUFAN1 / SYSFAN1 / SYSFAN2 Full-Speed Duty
