21
Step or Intel Speed Shift to be available and enabled.)
The optional settings: [Disabled]; [Enabled].
*
Note:
‘Turbo Mode’
item may or may not show up, depending on different CPU.
SATA Configuration
Press [Enter] to make settings for the following sub-items:
SATA Configuration
SATA Controller(s)
Use this item to enable or disable SATA Device.
The optional settings: [Enabled]; [Disabled].
When set as [Enabled], the following items shall appear:
SATA Mode Selection
This item determines how SATA controller(s) operate.
The optional settings: [AHCI]; [RAID].
SATA1/SATA2/SATA3/SATA4/SATA5/SATA6/SATA7/SATA8
Port
Use this item to enable or disable SATA Port.
The optional settings: [Disabled]; [Enabled].
*
Note:
Q470E chipset supports SATA1 to SATA6, W480E supports SATA1 to
SATA8.
Hot Plug
Use this item to designate this port as Hot Pluggable.
The optional settings: [Disabled]; [Enabled].
PCH-FW Configuration
Press [Enter] to view Management Engine Technology Parameters and make
settings in the following sub-item:
ME Firmware Version
ME Firmware Mode
Firmware Update Configuration
Press [Enter] to make settings for ‘
Me FW Image Re-Flash
’.
Me FW Image Re-Flash
Use this item to enable or disable Me FW Image Re-Flash function.
The optional settings: [Disabled]; [Enabled].
*
Note
:
In the case that user needs to update Me firmware, user should set
‘Me
FW Image Re-Flash
’ as [
Enabled
], save the settings and exit. The system will
turn off and reboot after 4 seconds. If the user goes to BIOS screen again will find
this item is set again as [
Disabled
], but user can still re-flash to update firmware
next time.
AMT Configuration
Use this item to configure Intel(R) Active Management Technology Parameters.
Press [Enter] to make settings for the following sub-items:
USB Provisioning of AMT
Use this item to enable or disable AMT USB Provisioning.
The optional settings: [Disabled]; [Enabled].
CIRA Configuration
This item is for user to configure Remote Assistance Process parameters.
