Jetter JetWeb JetMove 203-230, User Manual, Page: 66 / 90

9 Diagnostics JetWeb
66 Jetter AG
F 05 Current overload The output current
has been greater
than 2.5 x the rated
current – Immediate
pulse disable
– Check cable and
motor for a short
circuit
– Check current control
parameters. If
necessary, correct
parameters
– Acknowledge failure
F 06 Overload internal
ballast resistor The ballast resistor
has been
overloaded – Immediate
pulse disable
– Let the drive
controller cool down
– After cooling down,
acknowledge failure
– Reduce regeneration
power
F 07 Shutdown
threshold for
device temperature The amplifier has
reached the
maximum
temperature – Immediate
pulse disable
– Let the drive
controller cool down
– After cooling down,
acknowledge failure
– Reduce power of
drive system
F 08 Shutdown
threshold for motor
temperature The motor has
reached the
maximum
temperature – Immediate
pulse disable
– Let the motor cool
down
– After cooling down,
acknowledge failure
– Reduce the power of
the drive
F 09 Encoder error Encoder breakage
or initialization error – Immediate
pulse disable
– For extended
diagnostics purposes
use motion setup
– Check the encoder
line and all plug-in
connections
– Acknowledge failure
F 10 Overspeed The actual shaft
speed has
exceeded a value of
1.25 x maximum
speed – Immediate
pulse disable
– Check motor and
encoder connections
– Check speed
controller parameters
If necessary, modify
parameters
– Acknowledge failure
F 11 Current overrange A current
temporarily too high
has been detected – Immediate
pulse disable
– Reduce K
p
of the
current controller by
10 to 20 %
– Acknowledge failure
Error Message Table JetMove 203-230
Error
Number Type of Error Description Effect Error Correction