JETSTOR SAS 760J/JD Hardware Installation Guide
Page 30 of 71
Chapter 5 Powering Up the JETSTOR SAS 760J/JD
This chapter describes how to power up and power down your JETSTOR SAS 760J/JD
system configurations.
Caution: Use only the power cords supplied with the enclosure.
Do not use another type of cord or extension cords. If you
require additional power cords, please contact your JetStor
sales representative.
NOTE:
The JETSTOR SAS 760J/JD ‘sequences’ the power supplied to the disk drives
on start-up to prevent an overcurrent condition. Different manufacturers, types and
capacities of the disk drives used will vary in the amount of time that the drives become
‘ready’. In most cases, waiting approximately one minute from power-on will ensure
that all drives are ready and available to the host operating system.
Prior to powering up the first time, plug the power cords into their respective power
supplies on the rear of the enclosure(s).
JETSTOR SAS 760J/JD Rear View
Power
Switches
Power Cords Plug in Here
