35
Refit the inner door frame and nuts hand tight. Finally tighten each nut a little at a time so as to pull the glass
down evenly to avoid it cracking.
This will allow the metal to expand when heated to avoid cracking the glass.
DO NOT OVERTIGHTEN THE BOLTS AND NUTS OR THE GLASS WILL CRACK.
Refit the door using the reverse process in door removal section.
Door Tension Adjustment
After carrying out any servicing on the door always check and adjust if necessary the door latch tension.
The latch tension is adjusted by adjusting the end of the door latch by bending slightly inwards or outwards to
achieve more or less tension when the door is closed.
This will adjust the tension of the door seal against the firebox body.
After any adjustment in the door tension always re-commission the fire.
Cleaning and Maintenance
To maintain the finish on Decorative Surrounds wipe with a soft damp cloth only.
Do not use
abrasive cleaners,
polish or solvents as these can damage the surface finish.
The visible front parts of the fire can be repainted with heat resistant black paint. These parts can be repainted
every 1 or 2 years as required but generally dusting with a soft brush should keep the fire looking good. The
interior of the firebox and the grate should not be painted.
Glass Door
If over a period of time the glass door starts to soot then this maybe cleaned with a proprietary cleaner available
from your distributor.
ALL CLEANING MUST BE CARRIED OUT WITH THE APPLIANCE COLD
Spare Parts available
Door Seal.
Flexible sealer for door seal.
Glass flat seal.
Flexible sealer for glass fitting.
Baffle boards, lower and upper.
Back and side boards.
Bottom grates.
Replacement handle.
Energy Labelling Classification
16i
18i
50i
60i
60i Low 70i
70i Low
Energy Efficiency Class
Energy Efficiency
105
113
112
112
103
102
96
