Page 15
Figure 3: Sheet Metal Enclosure showing dimensions for mounting.
Section VII Electrical Installation
A.
Input Power
The 9700W control is designed to operate on either 115VAC or 230VAC 50/60HZ and is fitted with
a 10 amp circuit breaker suitable for either voltage. The unit is typically configured for your choice
of voltage prior to shipment. The unit ships with a standard 6 foot length cable for 115/120 VAC
only input. If it is necessary to change the input voltage, this can be done as follows:
Make sure no power is apply to unit during this procedure.
Open the front door of the unit and locate the motor control module (Picture of jumpers on motor
drive). At the top, left hand side of the module there are two jumpers, these are marked J1A and
J1B. These should be set as shown in the diagram below.
Figure 4: Input Voltage change over.
