JETI model Max BEC 2D, Manual, Page: 6 / 12

voltage. Please note that these values are deleted automatically or can be deleted manually
using the Erase Data menu option. The values are automatically erased when the unit is switched
on and the input voltages exceed those specified in the Trigger Level menu option.
Accum. A MIN/MAX - Shows the minimum and maximum voltage of the battery connected to
input A.
Accum. B MIN/MAX - Shows the minimum and maximum voltage of the battery connected to
input B.
Temp. MIN/MAX - Shows the minimum and maximum temperature of the Max BEC 2D.
4.3 SETTING - Configuration Options
SETTING - By pressing the 'D' (Down) button, we can see the individual parameter settings of the
Max BEC 2D.
Erase Data - By simultaneously pressing the Left and Right button of the Jeti Box, all minimum
and maximum recorded values are erased (See also section 4.2)
Trigger Level - Set the voltage values, the first overshoot of which, the previously recorded
minimum and maximum values are erased and recording begins again (See also section 4.2)
Output (x.x) Volt - Set the output voltage of the BEC. Note that the output voltage of the BEC can
be set by jumper or programmed using the Jeti Box. By pushing the 'L' (Left) button, the BEC can
be configured purely by Jumper. By pushing 'R' (Right), the BEC output voltage can be set
directly from the Jeti Box, overriding the physical position of the Jumper.
Beep Volt. Alarm - Set the letter of the alphabet to be acoustically signalled from the transmitter
module when the input voltage falls below that specified by Trig. Level for WARN LED
Beep Temp. Alarm - Set the letter of the alphabet to be acoustically signalled from the transmitter
module when the temperature of the BEC exceeds the limit specified by Temp. Alarm (In the
Alarm menu - See section 4.4)
Trig. Level for WARN LED - The input voltage at which the red warning LED on the magnetic
switch-plate and on the BEC should become active. This is also the voltage at which the first
green LED should deactivate.
Step Value - The voltage value of each step between the green input voltage LED's on the BEC
(5.5-8.4V). The table below shows an example, assuming a step value of 0.4V and a trigger level
of 6.6V: