JETI model Central Box, User Manual

Page: 22 / 42

EN
4 Configuration via JETIBOX
The JETIBOX terminal can be used for parameter setting and
retrieving data. After connecting to the
Central Box ( CB100 output
Ext1 or CB210/220 output E1/R3 ), a startup screen appears that
contains identification of the device in the first line of the JETIBOX
display. The second line contains the data showing the consumed
capacity of
batteries .
By pushing the R button (to the right) on the JETIBOX, you get to the
expander menu.
For the Central Box 2 10/220 :
In the expander menu, the second lines display the sensors that are
connected to inputs
E1/R3, E2/15 and E3/14.
Using buttons U and D (down and up arrows) of the JETIBOX it is
possible to browse through the expander inputs. The selected
input is marked with a curly bracket brace after the input number,
eg. 1}. By pushing the
R button (right arrow) it is possible to enter a
selected sensor, where you can adjust and display its parameters.
For the Central Box 100:
In the expander menu, both lines of the menu of the sensor that is
connected to the
Ext. are displayed .
Return from the sensor menu:
-
by holding the L button (left arrow) for extended time
- by holding the L button (left arrow) for short time, in
case you are in the basic menu of the sensor (in the first line there is
identification of the sensor and in the second line there are actual
data, such as „MUI 30; 14,2V 7,8A“)
The input marked 1}… means that there is no device connected to
this input or the connected device is not compatible, or the input
from the Central Box is not properly configured.
By pushing the D button (down), you get from the initial screen of
the Central Box to its menu.
21 EN