EN
• R1
- primary input for connecting receivers with serial output
(EX bus, PPM or S.BUS)
• R2
- secondary input for connecting receivers with serial output
(EX bus, PPM or S.BUS)
• SW
- input is reserved for connecting a magnetic switch or RC
switch (optional accessories).
• BATT1
and
BATT2
– MPX connectors for connecting batteries or
a BEC, etc., to power the servos and receivers connected to
the Central Box.
2.1.2
Central Box 2
20
• Central Box 220
has 15 outputs for servos (support of DITEX
telemetry servos) with individual overload protection. Each of the
outputs can be operated in these modes:
- servo output (default setting)
- Digital output
- Digital input
- Ditex
• Channels 1, 2, 9
and
10
have protection for high-torque servo
up to 60 Kg.cm.
• Channels 3 - 8
and
11 - 15
have protection for standard servo
up to 30 Kg.cm.
• Channels E3/14
and
E2/15
are also configurable to alternative
uses, such as:
- an input for telemetry sensor
- EX Bus expander – used for connecting devices which
support the EX Bus protocol (the Central Box, a sensor,…)
- S.BUS Output (only channel E2/15)
• E1/R3
port can be configured for use as:
- an output to connect a JETIBOX or Duplex EX receiver to
configure the Central Box
- an input for telemetry sensors
- EX Bus expander - used for connecting devices which
support the EX Bus protocol (the Central Box, a sensor,…)
- an input for receiver (supports only EX Bus protocol)
6 EN
Summary of Contents for Central Box
Page 1: ...EN User Manual EN...
Page 41: ...EN 40 EN...
