EN
Caution:
It is not recommended:
-
to connect more Central Box outputs to one servo
-
to use a Y cable (connecting two servos to one
output)
Caution:
R1, R2, E1/R3 are not protected against overload. The
maximum output current is 200mA for each output.
3.4
Connecting Central Box – EX Bus
3.4.1 Central Box 210/220
Receivers can be connected to the Central Box 210/220 using the
R1, R2
and
E1/R3
inputs.
Input
E1/R3
is necessary to set to a Receiver.
The serial link of the receivers (Ext.) has to be set to EX Bus.
Configuring the Central Box 210/220 is done directly in the
transmitter via EX Bus (Device Explorer).
When operating the Central Box 210/220 with DC/DS transmitter, it
is recommended to use two/three receivers communicating with
the transmitter in the wireless mode
„Double path"
and Enable 900
MHz Backup
The Central Box 210/220 can be configured in two ways:
-by JETIBOX connection (directly to the Central Box or
wirelessly via the transmitter)
- by DC/DS transmitter via Device Explorer (EX Bus)
see „Fig. 9"
3.4.2 Connecting Central Box 100
Receivers can be connected to the Central Box 100 using the
Rx1
and
Rx2
inputs.
The serial link of the receivers
(Ext.)
has to be set to
EX Bus
.
Ext. is an input for telemetry sensor. Telemetry is transmitted to the
receivers via EX Bus. Ext. can also be configured as an EX Bus output.
15 EN
Summary of Contents for Central Box
Page 1: ...EN User Manual EN...
Page 41: ...EN 40 EN...
