Install Appendix
Fan System Layout
Note it is best to connect to switchboard on a separate circuit, to ensure nothing
else interferes with the fan. It is possible however to connect to a power point if
necessary. It is installer responsibility to ensure all cable is appropriately installed
as per NZ electrical standards.
Recommended to put the fan controller in sight of the fan and within easy access
of customer. Commonly placed by the main light switches.
Fire relay can be installed by electrician and connected by fire alarm technicians.
Trouble Shooting and Error Codes
Common causes for the malfunctioning operation:
1.
The external power supply of the control box is not valid.
2.
Open the master switch, and then turn on the three gears control switch, if
the fan can still not work, please check whether the speed knob is of the MIN
state.
Review the VSD drive booklet for further error codes and fixes. Non-professional
staffs do not open the electrical control box!
Notes
: Equipment damages due to the improper use are not covered by the
warranty. Personal injuries and equipment damages for your failure to comply
with the contents of this manual, the Company will not bear any responsibilities.
Fan Installation
NOTE: You can swap steps 1 and 2 if preferred
–
both methods are good.
1.5 3 core plus earth
2.5 2 core plus
earth
Dedicated circuit on
switchboard preferred
