1.
Preparing the Fan Motor Assembly
1.1
Insert the motor wire through the down rod and carefully pull it to leave
minimum slack.
1.2
Put the Black Metal Ring over the motor
–
this sits here until it is installed at
step 5
1.3
Install the Down rod on the motor with the provided M16 X 25mm hardware.
(1.1 Image)
(1.2 Image)
Notes:
•
Down rod is square not rounded as per images.
•
Do not pull the motor wire with excessive force which may cause the wire
to disconnect from the motor terminal.
•
Motors show connecting arms attached, these arms in fact get connected
at step 5.
2.
Preparing the Mounting Assembly
2.1 Fix the mounting plate to the mounting structure using Clamping plates,
Shims and M16 x 55mm hardware as shown in the figure below.
NOTE
:
