Being careful not to move the scale, unlock and lift fence
from the table.
Tighten screw (S3) to secure scale in position.
If further adjustment is needed, wing screws (HP4) can be
loosened to allow adjustment of guide rail (E).
Quick-tension handle
Install quick-tension handle into hub on back of saw. (see Q,
Figure 11), and tighten using a wrench on the flat of the
shaft.
Fig. 11
Setting the table square to sawblade
Tools Required : Small 90 º square (
not supplied
)
The table can be set at 90º to the sawblade by adjusting the
table stop screw underneath the table. Fig. 12
Fig 12
Refer to Figure 13:
Loosen the nut (A, Fig 13), adjust bolt (B).
Fig. 13
Checking the table for flatness
A steel rule should be held on the table across the table slot
close to the front edge of the table. (See Fig. 14)
Fig. 14
If the straight edge shows there is a step across the table
slot then the table needs to be adjusted using the two
screws and locking nuts provided for this purpose, located
on the underside of the rip fence guide, at (D, Fig 14)
Lower blade guard
When open the lower bandwheel door on this machine the
lower blade guard (Fig 15)
.
