14
Laser Assembly Removal/Installation
The JDP-17DX drill press can be used as a
mortiser when fitted with a mortiser adapter (not
included). When used as a mortiser, the laser
assembly must be removed as follows:
Referring to Figure 14:
1. Unplug machine from the power source.
2. Remove the
chuck and arbor
assembly (de-
scribed on page 7).
3. Remove
nuts
(A, C), and
washer
(B) from the
depth set bolt
(H
2
).
4. With a 5mm hex wrench, loosen the
socket
head cap screw
(J) on the
laser housing
(H)
and lower the assembly.
5. Disconnect
wiring
connectors
E
1
, E
2
.
This completes the removal of the laser assembly.
To re-install the laser assembly:
1. Reconnect the wiring. Note that each E1
connector can be connected to any E2
connector (order is not important).
2. Install the laser by passing the
sleeve
(H
1
) and
depth seat bolt
(H
2
) through the head casting
opening (F) and
seat
(D) respectively, the n
seating the
laser housing
(H) onto the
quill
(G).
3. Secure assembly by tightening
socket head
cap screw
(J).
This completes the laser assembly installation.
Important:
After installation, lasers must be
recalibrated as described in the
Laser Adjustment
section (page 13).
Lamp
A light bulb is not included. If desired, insert a
standard 60W bulb into the socket accessible from
bottom of head.
Figure 14
