Jet J-2500, Operating Instructions And Parts Manual

Page: 14 / 56

14
Figure 18
Extension Cords
Make sure your extension cord is in good condition.
When using an extension cord, be sure to use one
heavy enough to carry the current your machine will
draw. An undersized cord will cause a drop in the line
voltage resulting in power loss and overheating. The
table following shows the correct size to use depending
on the cord length and nameplate ampere rating. If in
doubt, use the next heavier gauge. Remember, the
smaller the gauge number, the heavier the cord.
Length of Cord AWG
00 0 – 25 Feet 16
0 25 – 50 Feet 14
The drill press with a 230-volt plug should only be
connected to an outlet having the same configuration
(D, Fig. 18). No adapter is available or should be used
with the 230-volt plug.
Important: In all cases (115 or 230 volts), make certain the
receptacle in question is properly grounded. If you are not
sure, have a registered electrician check the receptacle.