9
Figure 4
7.3
Assembly
Refer to Figure 4.
Band Saw should be
disconnected from electrical power during
assembly and setup.
1. Remove brackets holding saw to pallet.
2. Use properly rated lifting equipment (hoist or
forklift) with straps placed beneath cast iron
portion of saw.
3. Use blocking beneath saw, and install foot
stand (H). Secure with four screws and
washers (HP-1/2/3).
4. Install axle and wheels (F/G). Install cotter
pin (HP-8) through hole in axle, and bend
back legs of cotter pin to secure each wheel.
5. Slide workstop rod (B) into hole on saw base
and slide workstop (A) onto rod. (NOTE: Do
not insert rod too far so that it hits the vise
leadscrew).
6. Install handle (E), and place filter screen (C)
over coolant drain hole in pan.
7. Remove stop bolt (X, Figure 4) and remove
shipping bracket (Y). Retain bracket in case
you must transport the machine in the
future.
Reinstall stop bolt
.
After removal of shipping
bracket (Y), the stop bolt (X) must be
reinstalled and properly adjusted to prevent
damage to the on/off switch.
7.4
Vertical cutting plate
These steps are only necessary when using
band saw in vertical position.
1. Disconnect machine from power source.
2. Raise bow to vertical position.
3. Remove two screws and remove seat plate,
as shown in Figure 5.
