13
Saw Blade
All Models
The 708315 Table Saw comes with the saw blade
already included and installed from the factory. To
replace a blade, see
Replacing the Blade
in the
Adjustments
section.
Attaching the Rip Fence
All Models
Referring to Figure 9:
1. Raise the rip fence
handle
(A) as shown.
2. Position
the
rip fence
(B) over the
table
(C) as
shown, holding up the front end while engaging
the
holding clamp
(D) to the rear, then lowering
the
front end
(E) onto the
rail
(F).
3. Lower
the
handle
(A) to clamp the fence to the
table
Calibrating the Rip Fence Scale
All Models
1. Attach
the
rip fence
to the
table
(as described
in the previous section) to the right of the
saw
blade
, but do not lower the
handle
to clamp the
fence to the table.
2. Slide
the
fence
against the
saw blade
.
You will need to raise the
blade guard
and the
anti-kick pawl
to provide clearance for the
fence.
3. With the fence snug against the saw blade,
clamp the fence in position by lowering the
handle.
Referring to Figure 10:
The hairline on the
indicator
(A) should line up with
0" on the
rail
(C). If they do not line up:
4. Slightly loosen the
screw
(B).
5. Slide the indicator until the hairline lines up with
0" on the rail.
6. Tighten the screw.
Figure 9
Figure 10
Summary of Contents for 708315BTA
