16
Mounting the Left Extension Wing Assembly
Model LSB only
The
left extension table
, identified by the
scale
(B, Fig. 16) on the rail, is used only with
model
LSB
The assembly and mounting procedure is the same
manner as for the right extension wing (above).
Left Scale Extension
Model LSB only
Referring to Figures 16:
1. If necessary, loosen the extension table lock
knobs and slide the
extension table
(D) flush
against the
saw table
(E).
2. Take the
left rail extension
(A) identified by
scale range
11"–21"
and insert into the
left
extension table guide rail
(B), sliding it all the
way through and into the
table guide rail
(C).
3. View from underneath and adjust until the two
holes in the
rail extension
(A) and
table rail
(C)
are aligned.
4. Insert two each M4x10
pan head screws
(J),
M4
lock washers
(K) and M4
flat washers
(L) to
hold the extension rail in place, but leave loose
enough to permit adjustment (following steps).
5. Place a
scale
or
yardstick
(F) across the
extension table and saw table.
6. Align the 11" mark on the ruler (G
1
) with the 11"
mark on the guide rail (G
2
) and hold ruler firmly
in place while performing the next step.
7. Adjust
the
rail extension
(A) until the 18" mark
(H
1
) is aligned with the 18" mark on the
ruler (H
2
). Release the ruler while making sure
the rail extension does not move.
The
left rail extension
is now properly
calibrated. While holding it in place:
8. Tighten the two
screws
(K).
Right Scale Extension
Models BTC, LSA and LSB
The assembly steps are the same as for the Left
Scale Extension. For the alignment, use 14" and
21" as the calibration marks.
Figure 16
Summary of Contents for 708315BTA
