EN
-
12
BA-0016 • 2020-10-15
7 Setting the working parameters
WIG 165i
7 Setting the working parameters
The selected working parameters are saved when the machine is switched off and enabled when it is
restarted. The individual values can be adjusted by pressing the “+” (I on page EN
10) buttons and are shown on the display (O on page EN
10). If the function is used in the welding
process, the respective indicator light flashes. It is not possible to change the parameters during the welding
process.
The following settings can be configured by pressing the “P” button (G on page EN
10):
8 Maintenance and cleaning
Welding current
Indicator light A on page EN
10 illuminates. The desired welding current can be
set by pressing the “+” or “−” buttons. This setting can also be changed during
the welding process.
Slope-up time
The Su indicator light (C on page EN
10) illuminates. The function is activated
and can be adjusted from 0 to 100 using the “+” and “−” buttons. (0 means
instant increase; 100 means delayed increase depending on the welding
current, e.g. 100 means 14 seconds at 165 A.)
Slope-down time
The Sd indicator light (D on page EN
10) illuminates. The function is activated
and can be adjusted from 0 to 100 using the “+” and “−” buttons. (0 means
instant decrease; 100 means delayed decrease depending on the welding
current, e.g. 100 means 14 seconds at 165 A.)
Post gas
The Gn indicator light (E on page EN
10) illuminates. The function is activated
and can be adjusted from 0 to 25 seconds in 0.2 second intervals using the “+”
and “−” buttons.
Overheating
The overheating indicator light (F on page EN
10) illuminates. The machine is
overheating and shuts down. After a cool-down period of about three minutes
with the fan running, the machine is ready for operation again.
Faults
The fault indicator light (B on page EN
10) illuminates. The control system has
detected a fault and switched off the machine. The applicable error code
appears on the display (O on page EN
10). Help on faults can be found in
section 10 Troubleshooting on page EN
NOTICE
For safety reasons, the machine must be subjected to an annual safety inspection by Jäckle & Ess System
GmbH or another authorised specialist pursuant to DIN IEC 60974 part 4:
• Arc welding equipment, periodic inspection and testing
DANGER
Electric shock
The following instructions must be adhered to during all maintenance, servicing, assembly, disassembly
and repair work:
• Switch off the power source.
• Close off the gas supply.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
