Jerdon J513W, Instruction Manual, Page: 4 / 16

Steam Ironing: Fill iron with water per the To Fill Water Tank
directions. Plug the appliance into the electrical outlet. Set the
Fabric/Temperature Dial to MAX (if the iron is not set to MAX
water may leak from the soleplate). The Power Indicator Light
will glow showing the iron is heating. When the Power Indicator
Light no longer glows you may begin ironing. Dependent on the
model you have you can increase or decrease steam output by turning the steam
control knob or by moving the steam control to button to 1-5.
Steam Spray
Note: The steam setting should not be used on Synthetic Fabric, Nylon, Synthetic
Silk or Silk as damage to the fabric could occur.
Automatic Shut-off: This iron is equipped with a safety device that automatically
switches off the heating element if the iron is left motionless for 30 seconds in a
horizontal position or 15 minutes in a vertical position. Pick up the iron or move it
slightly to reactivate heating.
Steam Button : This function works well for tough wrinkles and heavy fabrics. Fill
the water tank to the MAX position. Set the Fabric/Temperature Dial to MAX until
the Power Indicator Light goes off. Release the steam by pressing the Steam
Button. Let the steam penetrate the fabric and then generate more steam by
pressing the Steam Button again. For optimal results, there should be 3-5 seconds
rest between presses of the steam button. To prevent water from leaking from the
soleplate, do not press the steam button continuously for more than 5 seconds.
Spraying Methods: Fill the water tank with water. Press water spray button.
C
LEANING
Y
OUR
I
RON
This appliance contains no user serviceable parts. Do not try to repair it yourself.
To Clean: Once a month clean the iron to remove any scales or impurities. Fill
water tank ½ full of water. Note: Never use a descaling chemical in your iron. Place
the iron on the heel rest. Plug into an electrical outlet and turn the
Fabric/Temperature Dial to the highest heat setting and the Steam Control Knob to
the maximum steam position. Allow iron to heat until the Power Indicator Light goes
off. Turn off and remove the plug from the outlet. Hold the iron horizontally over the
sink. Set the Steam Control Knob to maximum and boiling water and steam will
begin to flow from the steam holes in the soleplate. Move the iron forward and
backward to help expel impurities. When steaming stops, repeat procedure until the
water tank is empty.
To Clean Soleplate: The iron should be fully cooled before soleplate cleaning
begins. Apply a small amount of mild cleaner to a damp cloth. Gently rub soleplate,
then wipe with a moist cloth.
To Store : Unplug appliance and allow to cool. Pour out any water left in the iron.
Store in upright position on heel rest. Never store iron lying on soleplate. Never
wrap the cord tightly around the appliance, keep cord loosely coiled or wound around
cord winder. Do not put any stress on the cord where it enters the unit, as it could
cause the cord to fray and break.
4