Jerdon J513W, Instruction Manual, Page: 2 / 16

2
•
To reduce the risk of contact with hot water emitting from the steam vents,
check appliance before each use by holding it away from body and operating
steam button.
SPECIAL INSTRUCTIONS:
•
To avoid a circuit overload, do not operate another high wattage appliance on
the same circuit.
•
While use of an extension cord is not recommended, if you must use one, make
sure the cord has the same or higher wattage as the appliance (wattage is
stamped by the soleplate of the unit). Position the extension cord so that it
cannot be pulled or tripped over.
SAVE THESE INSTRUCTIONS
POLARIZED PLUG – This appliance may have a polarized plug –one blade is wider
than the other. To reduce the risk of electric shock, this plug is intended to fit into a
polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician. Do not attempt to modify
the plug in any way.
1. Never pull or yank on cord or the appliance.
2. To insert plug, grasp it firmly and guide it into outlet.
3. To disconnect appliance, grasp plug and remove it from outlet.
4. Before each use, inspect the line cord for damage. If damage is found, do not
use appliance.
5. Let iron cool completely before wrapping cord. Never wrap the cord tightly
around the appliance as this could place undue stress on the cord where it
enters the appliance and cause it to fray and break.
DO NOT OPERATE APPLIANCE IF THE LINE CORD SHOWS ANY DAMAGE OR
IF APPLIANCE WORKS INTERMITTENTLY OR STOPS WORKING ENTIRELY.
SPECIAL ATTENTION: This appliance is designed with a protective coating around
the heating elements. When plugged in and operating for the first time, there may be
momentary smoking while this coating is initially heated. This represents no danger
to the user and does not indicate a defect in the unit. When using for the first time,
allow the appliance to continue heating until the smoke dissipates. This should last
only about 30 seconds.
O
PERATING
I
NSTRUCTIONS
Before using the first time: Remove any sticker or protective foil from the
soleplate. Preheat; move iron over an old cloth several times to remove any residue
from the soleplate.
A – Spray Nozzle B – Water Filling Opening C – Steam Control Knob
D – Steam Button E – Spray Button
F – Fabric/Temperature
Dial
G – Fill Indicator H – Power Indicator Light I – Auto-off Indicator