Jepson 9435 T3, Operating Instructions Manual

Page: 12 / 124

3. 60T carbide tipped saw blade for SML (Part no.
600535)
4. 60T carbide tipped saw blade steel and
stainless steel (Part no. 600530 40)
5. Thinfix (Part no. 600546) (Figure 13)
6. Excentric clamping system (Part no. 609910)
7. Mounting stand (Part no. 600526T3)
10.2. OPTIONAL SAW BLADES &
ACCESSORIES PSDC9435T3
1. 120T carbide saw blade for very thin steel and
other materials except SML (Part no. 600512I)
2. 90T carbide saw blade for stainless steel (Part
no. 600570NSF)
3. 90T carbide saw blade for steel and other
materials except SML (Part no. 600570)
4. 72T carbide saw blade for steel and other
materials except SML (Part no. 600580)
5. 60T carbide saw blade for steel and other
materials except SML (Part no. 600590)
6. 60T carbide saw blade for SML pipes (not for
steel) (Part no. 600591)
7. 66T carbide saw blade for mass steel (not
usable for stainless steel and SML) (Part no.
600595)
8. 96T carbide saw blade for aluminum (Part no.
600594)
9. Thinfix (Part no. 600546) (Figure 13)
10. Excentric clamping system (Part no. 609910)
11. Mounting stand (Part no. 600526T3)
11. RECOMMENDATIONS
In order to achieve an optimal saw blade
performance, please read the following recommen-
dations:
1. Fasten the work piece well
First check by hand if the work piece is safely
and solidly attached
- Clamp and cut pipes and round materials
individually only.
2. At the beginning insert the carbide tipped saw
blade carefully and gently into the material
and then continue sawing quickly.
3. Carefully remove chips deposited between
the carbide teeth during the work before
continuing to work.
4. Check the carbide saw blade regularly
for abrasion and broken carbide teeth.
If a blade becomes blunt due to wear and
broken teeth, replace it with a new one.
5. Always wear safety goggles when sawing.
6. Never reach into the running saw with your
hands. Keep clothing away.
7. Watch for the rotation direction when
mounting the saw blade.
8. Have saw blades sharpened only by
specialised sharpening services.
9. Saw blades can be re-sharpened 5 times on
average.
12. CORRECT CUTTING PROCEDURE AT 90°
PSDC 9435 T3 | PDC 9430 T3
12