Jepson 9435 T3, Operating Instructions Manual

Page: 14 / 124

13.5. ANGLE ADJUSTMENT FOR MITER CUT
Conversion to jack rafter is prohibited
on the 9410ND!
(1) (2) Put the knob a
half turn to the
left (1), with the
thumb locking
bow down (2).
The saw is now swiveled to both sides up to
45°. Adjust the desired miter angle on the scale.
For common angle precisely locating points are
available.
13.6. SLIDING STOP
The sliding stop (A) is already
exactly set to the angular
precision spindle motor by the
manufacturer. See label on the
round table (pivot). To reach even
a bigger cutting capacity, the slide
stop can pushed back by loosen the 4 Allen screws
The stopper has also displaced stop surfaces on
both sides. Advantage: for unstable and thin-walled
sections theses stopper surfaces can be adjust close
to the saw blade.
This will guarantee a clean cut and no blocking of
the saw blade by deviant back material.
Before you make the miter cut, keep
sure that the slide stop is in the correct
position. (A)
13.7. CLAMPING SYSTEM
The quick-release clamping system allows quick
pre-adjustment in order to avoid that, depending
on the workpiece size, the clamping device has
to be laboriously turned into position using the
clamping handle.
(1)
Turn the thumbscrew on (1).
(2) Pre-adjust now the tensioner
without threads in 3 different
positions. Fixation is done with the
threaded rod by turning the
tension handle. (1 + 2)
WARNING: Before starting the machine,
Please make sure that the material is
clamped firmly.
Article ID: 600653
Optional adapter for clamping of
round and square tubes
Ø 30mm - 70mm
13.8. START AND STOP THE MACHINE
Make sure that the mains voltage is the same as that
on the name plate of the machine indicated and
that the switch is off before you connect the device
to the mains.
Transportation lock:
The transportation lock keeps the
saw arm, and the saw head with
the blade in the lowest position.
To start the machine:
First: Press the safety
(1A) (1B) lever to release the
saw head. (1A) Start
it. Keep the saw head
down about 1 cm
(1B)
(2) (3)
On the switch handle
is a safety button (2).
To start the motor,
the safety button
and the on-off switch
to be pressed simultaneously. (2 + 3)
To turn off:
Release the on / off switch (3) and security button,
than the motor is stopped.
Keep the saw head back up the saw blade guard will
automatically close and lock the saw head in its final
position.
WARNING! Always turn off the machine
and unplug from the socket
immediately after use to prevent
accidents caused by untrained
personnel.
DMC 9410ND
14