E9
2.
Turn on the Bluetooth feature of your cell phone and turn down the volume to avoid sudden loud sound bursts
from the speaker. Enable the search or scan feature to find the JSB-1000 [xx.xx].
Note:
[xx.xx] is the last 4 digits of speaker Mac address. If you have more than 1 JSB-1000 within range,
make sure you are connecting to the appropriate speaker.
3.
Select "JSBW-1000" from the device list when it appears on your device screen. If required, enter the pass
code “0000” to pair (link) the JSB-1000 with your cell phone.
4.
After successfully pairing (linking) your cell phone with the JSB-1000, the Mode Indicator LED stops flashing
and remains lit blue. You can now play music from your cell phone or Bluetooth device wirelessly to the
JSB-1000.
Note:
If you want to connect the JSB-1000 to another cell phone after pairing
successfully, then you need to
turn off the Bluetooth on the paired cell phone first if it is in range before going through the above steps.
Otherwise, the JSB-1000 will automatically reconnect to the previously linked cell phone or device. Then
press and hold the Bluetooth
button to put the JSB-1000 into Bluetooth pairing mode, the LED
Indicator will be flashing Blue.
5.
Press the /- button to adjust the volume level.
6.
Press the PLAY/PAUSE
button to pause or resume playback.
7.
To turn off the JSB-1000 Bluetooth, press and hold the
/STANDBY button on main unit for 2 seconds to
turn the unit to standby mode. Mode Indicator LED turns red. Don’t forget to also turn off the Bluetooth feature
on your cell phone or Bluetooth device.
Notes:
1.)
Refer to manual of your cell phone or other Bluetooth enabled device for Bluetooth operation, since it may
vary from model to model.
2.)
If your Bluetooth enabled device does not support A2DP, it will not play the music through the speaker,
even after it's paired (linked).
3.)
If you are pairing (linking) your computer to the JSB-1000 using Bluetooth, you may need to set the
JSB-1000 as your computer’s default sound device.
Note:
In power on mode, If no sound playback or paused by user for 15 minutes, unit will turn into standby mode
automatically for power saving.
Re-linking to a cell phone or Bluetooth device
If your cell phone or Bluetooth device is already paired with the JSB-1000, but became unlinked at some point, even
with both Bluetooth devices turned on. You can re-link them by:
1.
Tap the
/
PAIR button to re-link your cell phone. The Mode Indicator LED will turn blue and flash while linking.
2.
Select the JSB-1000 from the devices list on your cell phone for linking. The Mode Indicator LED stops flashing
and remains lit blue if the JSB-1000 and your cell phone have been re-linked successfully.
3.
You can also re-link the JSB-1000 by using Bluetooth operation of your cell phone. Please refer to operation
manual of your cell phone for more information.
