E10
AUXILIARY INPUT
This unit provides an auxiliary audio signal input jack for connecting external audio devices like MP3 players, CD
players and listen to them through the speakers of this unit.
1.
Use an audio cable (included) with one 3.5 mm stereo plug on each end of the cable.
2.
To select auxiliary audio input, plug one end into the Aux IN jack on the back of main unit, unit will turn into
AUX mode automatically, Mode Indicator LED turns Yellow.
3.
Plug the other end of the cable into the Line-out Jack or Headphone Jack of your external audio device.
4.
Turn on the external audio device and the main unit.
5.
The volume level can now be controlled through the main unit. Operate all other functions on the auxiliary
device as usual.
NOTE:
If you connect this unit to the Line-Out Jack of your external device then you only need to adjust the volume
control of this unit. If you connected the Headphone Jack of your external device then you may need to adjust
both the volume control of your external device and the volume control of this unit to find the most desirable
volume setting.
In power on mode, If no sound playback or paused by user for 15 minutes, unit will turn into standby mode
automatically for power saving.
Press and hold the POWER
button for 2 seconds to turning off the unit when you finish listening. Don't
forget to switch off the power of your external device as well.
RESETING THE JSB-1000
Power Cycle Reset
In case of malfunction due to electrostatic discharge, the apparatus has to be reset by disconnecting it from mains
supply, wait at least for 60 seconds before reconnect the AC power cord.
If above steps cannot reset the unit, you may need to go through below process for factory reset.
Factory Reset
1.
In Power ON mode, press and hold the RESET button for 5 seconds until MODE indicator LED change to Red
2.
Release the RESET button, unit will go into set up mode.
3.
Waiting for about 2 minutes, MODE indicator stop changing color and flashing white.
4.
Clear catches of apps in your samrtphone. Go through SETTING UP THE JSB-1000 ON A NETWORK section
in the manual.
