E11
Note:
In Power ON mode, press and hold the RESET button longer than 5 seconds until MODE indicator LED change to
Red then Orange may drive speaker into Recovery mode, Orange LED flashing. If this happen, go through power
cycle reset procedures mentioned above and then factory reset procedures. Do not keep holding the RESET button if
the LED turns Red from other color.
SOFTWARE UPDATES
The JSB-1000 internal software will automatically be updated when updates become available, and when the
JSB-1000 is ON and connected to a Wi-Fi network. The LED Indicator will be flashing Orange during an update, and
the JSB-1000 will auto-reboot automatically after the update is finished.
NOTE
: Software updates can occur at any time, but they will normally be scheduled to occur in the middle of the night
to avoid interfering with your listening.
CARE AND MAINTENANCE
1. Do not subject the unit to excessive force, shock, dust or extreme temperature.
2. Do not tamper the internal components of the unit.
3. Clean your unit with a dry cloth. Solvent or detergent should never be used.
4. Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
5. Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps or motors.
CLEANING THE UNIT
To prevent fire or shock hazard, disconnect your unit from the AC power source when cleaning.
The finish on the unit may be cleaned with a dust cloth and cared for as other furniture, Use caution when
cleaning and wiping the plastic parts.
If the cabinet becomes dusty wipe it with a soft dry dust cloth. Do not use any wax or polish sprays on the
cabinet.
If the front panel becomes dirty or smudged with fingerprints it may be cleaned with a soft cloth slightly
dampened with a mild soap and water solution. Never use abrasive cloths or polishes, as these will damage the
finish of your unit.
CAUTION:
Never allow any water or other liquids to get inside the unit while cleaning.
Note:
This unit is not magnetically shielded and may cause color distortion on the screen of some TVs or video
monitors. To avoid this, you may need to move the unit further away from the TV or monitor if unnatural color shifts or
image distortion occurs.
