16
7. To remove the iPhone from JiMS-520i, press and hold the Button for few seconds to switch off
the device and then gently remove it from the docking connector.
8. To turn JiMS-520i off, press the STANDBY/ON Button again.
USING HEADPHONES (NOT INCLUDED)
Inserting the plug of your headphones (not included) into the Headphone jack will enable you to listen in
private. When using headphones, the speakers will be disconnected automatically.
Note: READ THIS IMPORTANT INFORMATION BEFORE USING YOUR HEADPHONES
1.
Avoid extended play at very high volume as it may impair your hearing.
2.
If you experience ringing in your ears, reduce the volume or shut off your unit.
3.
Keep the volume at a reasonable level even if your headset is an open-air type designed to allow
you to hear outside sounds. Please note that excessively high volume may still block outside
sounds.
CLOCK SETTING
The following procedures can be accomplished by using either the remote or the controls on the main
unit.
Setting the Time
The Clock can only be set in STANDBY mode.
1.
Press and hold the SET Button until the Hour digits flash.
2.
While the Hour digits are flashing, press and hold the
!
or
#
Buttons until the correct Hour digits
appear in the LCD Display.
Note: Make sure the hour is correctly set to AM or PM. If the PM Indicator is “On”, the time displayed is
PM. If the PM Indicator is “Off” the time displayed is AM.
It is important that the “AM” or “PM” setting is correct for proper operation of the Alarm function.
3.
Press the SET Button to confirm. The Minute digits will flash in the LCD.
4.
While the Minute digits are flashing, press and hold the
!
or
#
Buttons until the correct Minute
digits appear in the LCD Display.
5.
Press the SET button to exit and activate the new clock time to operate.
Setting the Alarm (s)
i.
JiMS-520i allows you to set two different wake-up times which can be used independently or
simultaneously ALARM1 or ALARM2 or ALARM1 and ALARM2.
ii.
The procedure for setting the alarm time for ALARM 1 and ALARM 2 are the same.
iii.
The following procedure describes how to set ALARM 1 alarm time:
1.
In STANDBY mode, briefly press the ALARM 1 Button. The Alarm1 Indicator will appear
steadily in the LCD Display.
2.
Press and hold the ALARM 1 Button until the Alarm1 Indicator flashes ( ) in the display. The
Docking System is now set to Alarm Wakeup mode.