9
i.
To activate the Remote Control, remove the protective film.
ii.
Point the remote control toward the front of the main unit. The effective range of the remote is
about 15~19 ft from the remote sensor and within an angle of about 45° from the front of the unit.
Remote Control Battery Replacement
Please replace your battery if the operating distance of the Remote Control drops drastically.
1.
Remove the battery cover.
2.
Install one new CR2025 Lithium battery into the battery compartment as
shown in the figure on the right.
3.
Replace the battery cover.
CAUTION:
The battery may leak or explode if incorrectly installed.
Battery Precautions
Follow these precautions when replacing the battery in this device.
1.
Use only the size and type of battery specified.
2.
Be sure to follow the correct polarity when installing the batteries as indicated next to the battery
compartment. Reversed battery may cause damage to the device.
3.
If the device is not to be used for a long period of time, remove the battery to prevent damage or
injury from possible battery leakage.
4.
Do not dispose of battery in fire, battery may explode or leak.
RADIO OPERATION
The following procedures can be accomplished by using either the Remote or the controls on JiMS-520i.
Listening To The Radio
1. Press
the Button to turn on the unit.
2.
Press the FUNCTION Button to operate the unit in radio mode if required.
Note: The Display will change from displaying the radio frequency to the current time 1 minute after the
system enters the radio function mode.
TO: PRESS:
Switch between AM/FM band
BAND Button repeatedly
Select FM MONO or ST mode
SET/FM MODE Button repeatedly
Scan radio station automatically
!
or
#
Buttons and hold for 1 second
Stop auto-tuning
!
or
#
Buttons again
Scan radio station manually
!
or
#
Buttons repeatedly
Adjust the volume level (00~35)
or - Buttons
Select the EQ
EQ Button repeatedly until the desired EQ shown in the Display
Stop output from the speakers
MUTE Button once
Resume output from the speakers MUTE Button again.
3. To check the current function mode, press the /- Buttons once. The Display will first show
