M
od
el
: J
en
se
nG
ril
l E
st
at
e 2
.1 E
ng
lis
h 2
01
9
7
JensenGrill - Coal/briquette and gas combination grill
III. BEFORE INSTALLATION
Check the box for any damage
The total grill assembled consists of 1 box
Extra equipment comes in seperate boxes.
- Gas cylinder compartment, 1 box
- Frying plate, 1 box
- Side burner, 1 box
- Side table, 1 box
- Rotisserie, 1 box
- Grill tool spatula or tong, 1 box
- Cover, 1 box
IV. INSTALLATION INSTRUCTIONS
Installation of the grill
Unboxing the grill
Take the top box off the grill, take of the supporters and plastic
bag and pull down the box in the front with your feet, to pull/drive
out the grill from the box.
Open the lid and take out the box lying on the grate
Lift the grill grate of the grill
First cut all the wires holding the grate and upper grate.
Set (48) in the brackets at the front of (47) then lift (47) first to
the vertical position before lifting it out of the grill.
Open the box from the grate and remove the contents con-
sisting of:
1 pcs. Height adjustment handle (50)
1 pcs. Grill grate handle (48)
1 pcs. Catch pan (23)
3 pcs. Flame tamers (26)
2 pcs. Coal trays (29)
2 pcs. Perforated plates (22)
2 pcs. Smoking plates (24)
3 pcs. Spacers (27)
1 pcs. Coal tray and grate cleaning tool (54)
6
19
54
16
Screw (50) onto the grill and place handle in top position
Place flame tamers in the grill
Place (26) in the grill by sliding the ends into the recesses in the
combustion chamber of each burner.
Place the coal trays (29) and spacers (27) in the grill
The height adjustment handle for the coal trays on the front
of the grill should be in the top position, which places the coal
trays (29) in the bottom position. Open (47) with (48) to the
locked vertical position. Place (29) and (27) under the grate
in coal tray holder (26). Do not overload the coal trays with
briquettes or coal, to avoid over heating the unit.
When (29) and (27) are in place, close (48) and (48) is removed.
48
47
52
32
50
26
54 27
29
48
47
17
