M
od
el
: J
en
se
nG
ril
l E
st
at
e 2
.1 E
ng
lis
h 2
01
9
15
JensenGrill - Coal/briquette and gas combination grill
D. HOW TO USE THE COAL TRAY AND
GRATE CLEANING TOOL
Lift the coal trays out of the grill using the supplied coal tray
and grate cleaning tool (lifting and pull upward toward the front
of the grill). The coal trays will ”hang” at an angle that makes it
easy to take them in and out of the grill.
Use the tool to clean the grate, by sliding the tool on the grate
in the slots
.
The tool can also be used for cleaning of the upper grate.
XI. TROUBLESHOOTING PERFORMANCE
ISSUES
Visible spark, but no ignition
• Avoid smoking cigarettes while troubleshooting
•
Close the gas regulator knob and turn off the gas at the
cylinder.
• Check the gas regulator, gas hose and the other intercon-
nection.
• Repeat ignition trial after 5 minutes.
If the grill still does not work, switch off the gas regulator
knob and turn off the gas at the cylinder.
Examin the following:
Is the gas container empty?
Change the gas cylinder.
Check if the regulator is installed correctly.
Pull the regulator off and reconnect it.
Reposition the lead of the flam thrower in relation to the combu
-
stion chamber.
The Flash barrow should be positioned at the bottom of the
hole in the front of the firebox. Adjust as necessary by ben
-
ding the electrode carefully.
Misplaced burner
Place the burner properly.
Clogging of the valve and the burner.
Remove the cotter pin located at the rear of the ”firebox” that
hold the burner in place and remove the burner. Check valve
mouth and remove any particles with thin wire.
Be aware that removing the burner should be in accordan-
ce with national rules.
Clogging of the gas hose.
Remove the hose from the grill and open the gas cylinder
regulator for 1 second to check for clogging and to allow
any particles to be blown out. A safety mechanism in the
regulator can close when you do this. The controller is reset
by removing the controller from the gas container and refit.