6
Installation
, cont.
Gravity Drain
Drain Pump (sold separately)
To purchase an optional drain pump, contact the dealer
where you purchased the ice maker or Jenn-Air
Customer Assistance: 1-800-JENNAIR (1-800-536-
6247). Drain pump model number: JIMPUMPAXX.
NOTE:
Detailed installation instructions are provided
with the drain pump kit.
Drainage
Your ice maker uses a gravity drain that requires
5
⁄
8
" I.D.
tubing from the back of the ice maker to a plumbed
connection to a sanitary sewer (see illustration to the
below). Remove the access panel to plumb in drain
connection. Gravity drain location for built-in units can
be within the shaded area shown. An optional drain
pump can be purchased for your ice maker if a gravity
drain is not accessible.
NOTE:
Avoid kinks and check for proper water
drainage after ice maker installation.
OBSERVE AND FOLLOW ALL LOCAL CODES
WHEN INSTALLING ICE MAKER.
• Failure to use adequate drainage system will result
in surrounding water damage and/or poor ice
production.
• Water damage due to the use of an inadequate
drainage system may cause mold/mildew growth.
WARNING
14
3
⁄
4
"
2
3
⁄
8
"
6
3
⁄
4
"
1
1
⁄
4
"
4
1
⁄
16
"
23
1
⁄
2
"
21
1
⁄
8
"
3"
8"
15"
Front
of Unit
Top
of Unit
Gravity Drain Location
Baseplate
Opening for
Gravity Drain
Locate standpipe
as shown.
5
⁄
8
" I.D. Drain
Tubing and
Hose Clamp
1
1
⁄
2
" Drain Pipe
Access
Panel
Drain
Trap
Ice Maker
Power Cord
Drain from
Ice Maker
Tubing
Clamps
Discharge tube goes
through this opening
in the access panel.
Vent
Tube
Drain Pump
Power Cord
Vent tube goes through this
opening in the access panel.
Access
Panel
Drain Pump
Drain from Ice Maker
41007621 JA Ice Maker ENG 4/28/03 2:18 PM Page 6
