9
Type of
Pilot Hole Drill Size for
Wood
#8 Pan Head Wood Screws
Hardwood
3
⁄
32
" (.23 cm)
Softwood
5
⁄
64
" (.20 cm)
Prepare the Wood Panel
14
3
⁄
4
"
(37.47 cm)
Custom panel
thickness:
5
⁄
8
" to
3
⁄
4
"
(1.57-1.91 cm)
25
5
⁄
8
"
(65.07 cm)
10 Pilot Hole
Locations
Inside of Door
Attach the Wood Panel to the
Ice Maker Door
1. Place the custom wood panel on a non-abrasive
surface, protected by towels or rugs, to avoid
accidental damage to the door finish.
2. Place the ice maker door flush with the inside
surface of the custom wood panel. Clamp the
wood panel to the door, if necessary.
3. Mark the hole locations with a pencil.
4. Drill the pilot holes into the custom panel.
5. Insert the wood screws through the back of the
door and into the pilot holes in the custom wood
panel and tighten.
6. Reinstall the door seal by pressing it into the door
channel. Making certain the corners are fully
inserted.
7. Install the door back on to the ice maker using the
supplied plastic washers (as shown below).
8. Realigning the door may be necessary (see page 8).
Top Hinge Corner
Cabinet Hinge
Shoulder Bushing
Door Hinge
Washer
(Optional)
Bottom Hinge
Corner
Cabinet Hinge
Shoulder Bushing
Door Hinge
Washer
•
Door can become disengaged if washers are not
installed.
•
Door may not swing properly if all nylon components
are not installed as shown.
CAUTION
Wood Screws
1. #8 pan head wood screws are recommended to
properly secure the custom wood panel to the ice
maker door.
2. A total of 10 screws are needed.
3. Use only pan head screws.
4. Be sure the screw length is
NOT
longer than the
wood thickness at the screw locations.
5. Use the following pilot hole drill sizes.
41007621 JA Ice Maker ENG 4/28/03 3:15 PM Page 9
