© 2004 Maytag Services
16022514 Rev. 0
A–3
Installation Instructions
,QVWDOODWLRQ
A WIRING DIAGRAM IS ENCLOSED IN THE
ENVELOPE WITH THIS BOOKLET; ALSO THERE IS A
DIAGRAM GLUED TO THE UNIT, BEHIND CONTROL
PANEL.
Check the oven model number plate to see if the oven is
approved for installation in mobile homes and/or
recreational vehicles. If approved the following items are
applicable. NOTE: Oven model number plate is located
on bottom of control panel lower trim.
j e
The installation of an oven designed for mobile home
installation must conform with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, part
3280 (formerly The Federal Standard for Mobile Home
Construction and Safety, Title 24, HUD part 280) or, when
such standard is not applicable, the Standard for
Manufactured Home Installation, ANSI A225.1/NFPA
501A, or with local codes.
In Canada the oven must be installed in accordance with
the current CSA Standard C22.1 - Canadian Electrical
Code Part 1 and Section Z240.4.1 - Installation
Requirements for Gas Burning Appliances in Mobile
Homes (CSA Standard CAN/CSA - Z240MH).
o~~ s
The installation of an oven designed for recreational
vehicles must conform with state or other codes or, in the
absence of such codes, with the Standard for
Recreational Vehicles, ANSI A119.2-latest edition.
In Canada the oven must be installed in accordance with
CAN/CSA - Z240.6.2 - Electrical Requirements for R.V.’s
(CSA Standard CAN/CSA - Z240 RV Series) and Section
Z240.4.2 - Installation Requirements for Propane
Appliances and Equipment in R.V.’s (CSA Standard
CAN/CSA - Z240 RV Series).
`~~ a
For complete information in regard to the installation of
wall ovens and clearances see the installation drawings.
i~ q r
The installation drawing, gives the minimum dimensions
of the cabinet cut-out for the oven and the location of the
gas and electrical outlets. The dimensions given are for
the oven bottom to be a minimum of 12
²
inches above the
floor. The recess in which the oven is to be installed
should have a solid floor and be so constructed as to
provide a complete enclosure around the recessed
portion of the oven to prevent drafts which may result in
inconsistent and unsatisfactory burner and baking
performance, it should be perfectly level to provide a
solid, level foundation for the oven unit. The openings in
the enclosure for gas and electric service should be
sealed before the oven is installed. Air for combustion
enters at the extreme bottom of front panel. Do not block
or obstruct this opening.
For
p^cbqv `lkpfabo^qflkp
fasten the oven to the
cabinet with the four (4) screws (shipped with the unit)
through the holes in the trim behind the oven door. The
unit should
properly before being secured to
the cabinet.
